Table of Contents
Advertisement
10.
Unplug the cable at the right end of the Sensor Slave Assembly as shown in Fig-
ure 7-38.
11.
If the RLS is not rack-mounted, carefully turn it on its left side (as seen from the
front) so that the Storage Array mounting screws located on the bottom of the li-
brary can be accessed.
12.
Using a No. 2 Phillips screwdriver, remove the lower or left two screws from the
chassis bottom that hold the Sensor Slave Assembly in place (see Figure 7-39).
Grasp the assembly before removing the top (last) screw and then gently pull it
out through the Front Panel/Door.
13.
There are three or five (model dependent) Storage Array mounting screws locat-
ed on the bottom of the chassis. Using a No. 2 Phillips screwdriver, remove the
screws as shown in Figure 7-14. If the RLS is on its side, hold the Storage Array
Assembly in place with one hand while removing the final screw.
14.
Set the RLS chassis upright. Grasp the front and the rear of the Storage Array
Assembly and gently lift it up and then out through the front of the chassis.
7-22
Field–Replaceable Units (FRUs)
501510 Rev. S
Advertisement
Table of Contents
