Table of Contents
Advertisement
7.4 Opening the Front Panel/Door
When the RLS is powered-on, the Front Panel/Door can be opened as follows:
1.
Unlock the Front Panel/Door by turning the key clockwise.
See Section 3.1.
2.
Press the
not already in the menu system. To exit the menu system (from any menu),
press the MENU key twice.
There are two choices when opening the Front Panel/Door. The OPEN & PARK LEFT
command unlocks the Front Panel/Door and moves the carriage to its far left position.
This command should be used when accessing the Tape Drives. The OPEN & PARK
RIGHT command unlocks the Front Panel/Door and moves the carriage to its far right
position. This command should be used when accessing the Carousel or Storage Array.
3.
If the
OPEN & PARK LEFT
4.
If the
OPEN & PARK RIGHT
OPEN & PARK RIGHT
5.
After either command terminates, the Front Panel/Door will unlock automatical-
ly and pop open a fraction of an inch.
6.
After the carriage has stopped, gently pull the Front Panel/Door open.
If the RLS is not powered-on or is malfunctioning the Front Panel/Door can be opened
by following the steps below:
1.
Unlock the Front Panel/Door by turning the key clockwise. See Section
3.1.
2.
Insert the straightened end of a paper clip into the Emergency Unlatch Hole in
the Front Panel/Door as shown in Figure 7-1. Push on the latch tab to unlatch it.
The Front Panel/Door will pop open slightly when unlatched.
3.
Gently pull the Front Panel/Door open.
Do not place anything on the open Front Panel/Door as it is not designed to support
additional weight. Be careful never to lean on the Front Panel/Door, pull on it or lift the
RLS by it.
7-8
key to open the Quick Menu. The
NOTE
command is desired, simply press the ENTER key.
command is desired, press the
, then press the ENTER key.
CAUTION
Field–Replaceable Units (FRUs)
key only works when the RLS is
key to select
501510 Rev. S
Advertisement
Table of Contents
