Table of Contents
Advertisement
7.10 Front Panel/Door Assembly (Bezel)
RLS-4124
RLS-42/44xx
RLS-5116
RLS-5244
RLS-6227
RLS-8116
RLS-8202/8204/8204D/8236/
8236D/8244/8244D
RLS-8216C/8216CD/8236C/8236CD
RLS-84xx
The Carriage Assembly must be removed from the RLS before the Front Panel/Door
assembly can be replaced.
Tools and Materials Required:
•
No. 1 Phillips Screwdriver
•
No. 2 Phillips Screwdriver
•
Loctite 242 Threadlocker P/N 730-0017-6
7.10.1 Front Panel/Door Assembly Removal
1.
Remove the Carriage Assembly by following Section 7.7.1.
2.
Use a No. 2 Phillips screwdriver to remove the three screws that secure both
rack-mounting bracket to the sides of the RLS. See Figure 7-17.
3.
Slide the rack mounting brackets back to remove them from the library and set
them aside.
4.
Using a No. 1 Phillips screwdriver, remove the rear screw from the small link on
both sides. See Figure 7-18. These screws were installed with Loctite 242 and
will require more torque than normal to remove them.
5.
While supporting the Front Panel/Door assembly with one hand, use a No. 1
Phillips screwdriver to remove the upper screw from the large link on both sides.
See Figure 7-18. These screws were installed with Loctite 242 and will require
more torque than normal to remove them.
6.
Carefully remove the Front Panel/Door assembly from its threaded mounts and
set it aside.
501510 Rev. S
Field–Replaceable Units (FRUs)
(8mm)
P/N 510179-02-1
(8mm)
P/N 510179-01-3
(SAIT)
P/N 510179-02-1
(SAIT)
P/N 510179-01-3
(SDLT)
P/N 510179-01-3
(LTO)
P/N 510179-02-1
(LTO)
P/N 510179-01-3
(LTO)
P/N 510179-02-1
(LTO)
P/N 510179-01-3
7-29
Advertisement
Table of Contents
