Displays the type of Interface Personality Module installed in the RLS.
5.4.6 The Private\Cabling status screen
Indicates that the Carriage, Drivebay and Sensors ribbon cables are connected (OK)
or not connected (FAULT).
5.4.7 The Private\Calibration status screen
The Calibration Data Status screen displays the calibration data determined by the
CALIBRATION command. If, for example, the user encounters some particularly dif-
ficult Handler problem, it may become necessary to relay the data on this screen to a
Qualstar Technical Support technician.
The Calibrated value and the Valid value indicate whether or not the calibration data
determined by the CALIBRATION command is within acceptable limits. If the cali-
bration data is not valid, the Handler will not operate.
The following calibration data is displayed on the Calibration Data Status screen:
•
Calibrated (YES/NO)
This value shows whether or not the calibration process was successfully com-
pleted.
•
Valid (YES/NO)
This value shows whether or not the calibration data has been initialized.
•
X Data
This value is the position of the first Tape Drive Assembly.
•
X Fixed 0
This value is the position of the Fixed0 slot.
•
X Fixed 1
This value is the position of the Fixed1 slot.
501510 Rev. S
Private••••••Adapter
Type:
SCSI LVD/SE
Private••••••Cabling
Carriage:
OK
Drivebay:
OK
Sensors:
OK
Private••Calibration
Calibrated:
NO
Valid:
NO
ddddd
X Data:
ddddd
X Fixed 0:
ddddd
X Fixed 1:
ddddd
X Storage:
ddddd
Z Storage:
The Private Menu
5-13