Table of Contents
Advertisement
3.3.7 The Status LEDs
The three status LEDs display the current operational status of only the RLS Medi-
um-changer. Only one of them is illuminated at a time and they have the following
significance:
NAME
READY
BUSY
FAULT
Table 3-1 Status LEDs Descriptions
3.4 The Top Menu
To see the Top Menu, turn on the RLS, wait until it displays the date and time, then
press the MENU key. The operator should see a display like the one in Figure 3-3.
Display line one always
indicates the title (or its
abbreviation) of the
current menu or function.
The item pointer to the left of an
item indicates which item will be
acted upon when the ENTER key
is pressed. For example, press
ENTER when the arrow points to
Configuration and the display will
change to the Configuration menu.
Figure 3-3 Top Menu Display
If the arrow is positioned next to Operation and then ENTER is pressed, a display
similar to that shown in Figure 3-4 will be observed.
The up and down arrows at the right edge of the display indicate that additional
choices are available. These additional choices can be viewed by using the
(DOWN) keys to scroll the display.
To go back to the Top Menu from any point, press the EXIT key until the Top Menu is
displayed. The MENU key can also be pressed to accomplish the same result with a
single keystroke. To leave the menu system entirely, press the EXIT or MENU key
while the Top Menu is displayed.
501510 Rev. S
COLOR
GREEN
The RLS is ready to accept commands
AMBER
The RLS is busy executing a command
RED
A fault has occurred and the RLS cannot accept commands
A dot in front of an item indicates a
sub-menu. To go to the sub-menu,
press the ENTER key.
The Operator Interface
INDICATION
DOWN and UP arrows indicate
additional lines are to be seen by
scrolling the display with the UP
and DOWN key.
(UP) and
3-7
Advertisement
Table of Contents
