Sensor Master And Slave Assemblies - Qualstar RLS-4470 Technical & Service Manual

Tape library; rls-4000 series; rls-5000 series; rls-6000 series; rls-8000 series;

Table of Contents

Align the threaded inserts in the PCBA with the mounting holes in the right

side of the library's chassis and use a No. 1 Phillips screwdriver to reinstall the

two flat-head mounting screws. See Figure 7-35.

Reconnect the ribbon cable to the X-Clear Emitter PCBA. See Figure 7-34.

Align the mounting screw threaded inserts in the cover with the mounting holes

in the right side of the library's chassis and use a No. 2 Phillips screwdriver to

reinstall the Cover Bracket with five flat-head screws. See Figure 7-35.

Reinstall the Carriage Assembly into the RLS (Section 7).

Proceed to Section 7.24 to calibrate the RLS.

7.17 Sensor Master and Slave Assemblies

RLS-4124

RLS-4221

RLS-44XX

RLS-5116

RLS-52XX

RLS-62XX

RLS-8116

RLS-8216H

RLS-82XX/82XXD (LTO)

RLS-8404/8404D (LTO)

RLS-8444/8444D (LTO)

Sensor Master and Slave Assemblies are always replaced in pairs and the Carriage

Assembly must be removed from the RLS before the FRU can be replaced. The RLS

must be calibrated after replacing the Sensor Master and Slave Assemblies FRU.

Required Tools and Supplies:

•

No. 1 Phillips Screwdriver

•

No. 2 Phillips Screwdriver

•

5/64-inch Allen (Hex) Wrench

•

3-inch Cable Tie (P/N 669-1001-9)

501510 Rev. S

(8mm)