Table of Contents
Advertisement
SENSOR Connector
located here
Figure 7-36 The Sensor Master PCBA Bracket
7.17.1 Sensor Master Assembly Removal
1.
Remove the Carriage Assembly from the RLS as described in Section 7.7.1.
2.
Remove the rightmost Tape Drive Assembly as described in Section 7.11.1
3.
Disconnect the ribbon cable from the INTER connector on the left side of the
PCBA as seen from the front of the RLS. See Figure 7-36.
4.
Disconnect the ribbon cable from the SENSOR connector on the right side of the
PCBA as seen from the front of the RLS. See Figure 7-36.
5.
Cut and remove the two cable ties holding the power cable that runs between
the Drive Bay and Executive PCBAs.
6.
Using a No. 2 Phillips screwdriver, remove the two screws from the right side of the
RLS that hold the Sensor Master PCBA bracket in place. See Figure 7-37.
Front
2 Phillips Flat-Head Screws
on the Right Side of the Chassis
Figure 7-37 Screws that secure the Sensor Master PCBA Bracket in place
7-58
Sensor Master PCBA Bracket
2 Bracket Screws
on right side of chassis
Field–Replaceable Units (FRUs)
Interconnect PCBA
INTER Connector
located here
2 Allen Head Screws
on the Left Side of the Chassis
Front
501510 Rev. S
Advertisement
Table of Contents
