Show Ipv6 Access-Group; Mac Acls; Access-List Mac; Table 26-4 Mac Acl Commands - Edge-Core ES4626F Management Manual

26
Access Control List Commands
Related Commands
show ipv6 access-list (26-11)

show ipv6 access-group

This command shows the ports assigned to IPv6 ACLs.
Command Mode
Privileged Exec
Example
Console#show ip access-group
Interface ethernet 1/2
IPv6 standard access-list david in
Console#
Related Commands
ipv6 access-group (26-11)

MAC ACLs

The commands in this section configure ACLs based on hardware addresses,
packet format, and Ethernet type. To configure MAC ACLs, first create an access list
containing the required permit or deny rules, and then bind the access list to one or
more ports
Command

access-list mac

permit, deny
show mac access-list
mac access-group
show mac access-group
access-list mac
This command adds a MAC access list and enters MAC ACL configuration mode.
Use the no form to remove the specified ACL.
Syntax
[no] access-list mac acl_name
acl_name – Name of the ACL. (Maximum length: 16 characters)
Default Setting
None
26-12

Table 26-4 MAC ACL Commands

Function
Creates a MAC ACL and enters configuration mode
Filters packets matching a specified source and
destination address, packet format, and Ethernet type
Displays the rules for configured MAC ACLs
Adds a port to a MAC ACL
Shows port assignments for MAC ACLs
Mode Page
GC 26-12
MAC-ACL 26-13
PE 26-15
IC 26-15
PE 26-16