Connecting Audio Cables - IDK MSD-72 Series User Manual

MSD-72 Series User's Guide

7.2.3 Connecting audio cables

For audio input connector and audio output connectors, RCA pin jack or 5-pin terminal block can be used
depending on the model you use. Use the appropriate cables for the type of audio input connector and audio
output connectors.
Part number
MSD-7201UHD
MSD-7202UHD
MSD-7203UHD
MSD-7204UHD
MSD-7201UHDTB
MSD-7202UHDTB
MSD-7203UHDTB
MSD-7204UHDTB
■ RCA pin jack for audio input/output connectors
Use commercially available audio cables (RCA pin) if the MSD has RCA pin jack for audio input and output
connectors.
■ 5-pin Terminal block analog audio input/output connectors
Fix audio cable to the attached 5-pin terminal block, and then connecting to the MSD.
The MSD supports both balanced and unbalanced signal
IDK recommends using AWG 28 to AWG16 cable. The maximum peeling length is 7 mm (0.28 inch approx.)
Up to 7mm (0.28 inch approx.)
Lch +
Lch -
GND
Rch +
Rch -
Balanced signal (input/output)
[Figure 7.3] Connecting audio cable to 5-pin terminal block connector
26
[Table 7.3] Connetor types for analog audio input/output
Audio signal
Input channels
9 inputs
9 inputs
+
Lch
L
-
G
GND
+
Rch
R
-
Unbalanced signal (input)
Connector type for analog
Output channels audio input/output connector
1 output
2 outputs
RCA pin jack
3 outputs
4 outputs
1 output
2 outputs
5-pin terminal block
3 outputs
4 outputs
Up to 7mm (0.28 inch approx.)
+
L
-
G
+
R
-
Up to 7mm (0.28 inch approx.)
Lch
GND
GND
Rch
GND
Unbalanced signal (input/output)
+
L
-
G
+
R
-