Audio Setting - IDK MSD-6203 User Manual

9.10 Audio setting

HDMI digital audio supports formats mentioned in the table below. Set the audio depending on device
connected to the HDMI output connector.
Only "2 channel linear PCM" can be input by default. If you want to use "Multi channel linear PCM" or bit
stream signal, set "Audio format" and "Speaker configuration".
Audio format
2 channel linear PCM
Multi channel linear PCM
AC-3, Dolby Digital, DTS, Dolby Digital+,
DTS-HD, Dolby TrueHD, AAC
■ If multi channel linear PCM signal is input to digital audio:
For sink device and analog audio that do not support multi-channel linear PCM signal, 2 channels (ch)
that are set in "9.10.8 Multi channel audio output" or down mixed audio will be output.
Blu-ray disc player
■ If bit stream signal is input to digital audio:
Input audio is output to digital audio connector. It is not output to analog audio; audio volume cannot be
adjusted.
Blu-ray disc player
[Table 9.14] Audio format
2ch, 32 kHz to 192 kHz, 16 / 20 / 24 bit
8ch, 32 kHz to 192 kHz, 16 / 20 / 24 bit
Bit stream
5.1ch
Digital input
Matrix Switcher
Input level Output level
[Fig. 9.20] Multi channel linear PCM input
Bitstream signals
Switch
Digital input
Adjusting audio volume disabled
[Fig. 9.21] Bit stream signal input
MSD-62 Series User's Guide
【See: 9.11.5 Audio format】
【See: 9.11.6 Speaker configuration】
Description
5.1ch
Digital output
AV Amplifier supporting multi
channels
Selected 2 ch or down mixed audio
Analog output
Amplifier built in speaker
Any 2 ch or down mixed audio
Digital output
LCD monitor not supporting multi
channels
Digital output
AV Amplifier
Analog output
Analog audio not output
Amplifier built in speaker
99