Table of Contents
Advertisement
The following illustrations show the cabling information for the power paddle card:
Removing and replacing server components
This section provides information for removing and replacing components in the server.
Removing and replacing Tier 1 CRUs
Replacement of Tier 1 CRUs is your responsibility. If Lenovo installs a Tier 1 CRU at your request, you will
be charged for the installation.
The illustrations in this document might differ slightly from your hardware.
Removing a hot-swap hard disk drive
Use this information to remove a hot-swap hard disk drive.
Attention:
• To avoid damage to the drive connectors, make sure that the server cover is in place and fully closed
whenever you install or remove a drive.
• To make sure that there is adequate system cooling, do not operate the server for more than 2 minutes
without either a drive or a filler panel installed in each bay.
To remove a hot-swap hard disk drive, complete the following steps:
Step 1.
Read the safety information that begins in "Safety" on page v, "Handling static-sensitive devices"
on page 38 and "Installation guidelines" on page 36.
Step 2.
Press the release latch on the side of the drive front.
System board
power cable
Signal cable
Chapter 6
.
Removing and replacing components
177
Advertisement
Table of Contents
Troubleshooting
