Configuring The Lf Output With A Function Generator Source - Agilent Technologies E8241A User Manual

Configuring the LF Output with a Function Generator Source

In this example, function generator 1 is the LF output source.
Configuring the Function Generator as the LF Output Source
1. Press .
Preset
2. Press the
LF Out
3. Press
LF Out Source
Function generator 1 becomes the LF output source and FuncGen 1 is displayed below the
softkey.
LF Out Source
Configuring the Waveform
1. Press
LF Out Waveform
This creates a swept-sine output and opens a menu that configures the sweep parameters
of the swept-sine signal.
2. Press
LF Out Start Freq
This sets the swept-sine start frequency to 100 Hz.
3. Press
LF Out Stop Freq
This sets the swept-sine stop frequency to 1 kHz.
4. Press
LF Out Sweep Rate
This sets the swept-sign sweeps-per-second to 350.
5. Press >
Return Return
This returns you to the LF Output menu. The start frequency for the swept-sine waveform
is displayed below the
Configuring the Low Frequency Output
1. Press
LF Out Amplitude Into 50 Ohms
This sets the LF output amplitude to 3 Vp.
2. Press
LF Out Off On
This activates the LF output. The LF output is a 3 Vp swept-sine waveform, sweeping from
100 Hz to 1 kHz with a sweep rate of 350 Hz.
Chapter 2
hardkey.
>
Function Generator 1
> .
Swept-Sine
> > .
100 Hz
> > .
1 kHz
> > .
350 Hz
.
softkey.
LF Out Freq
>
.
Configuring the LF Output (PSG-A Series Only)
.
> .
3 Vp
Fundamental Operation
43