Lf Out Sweep Rate; Lf Out Sweep Trigger - Agilent Technologies E8241A User Manual

Key Reference
L

LF Out Sweep Rate

Supported
This softkey enables you to set the sweep rate for low frequency swept-sine output. The
signal generator will sweep from the specified start frequency to the stop frequency at
the rate set with this key.
Preset
Range
Location
Remarks

LF Out Sweep Trigger

Supported
Use this softkey to access a menu of choices that enables you to select the triggering
mode for the swept-sine low frequency output. You can choose triggering that occurs
immediately, triggering that is supplied by the GPIB, triggering on either a positive or
negative level of a signal supplied to the TRIGGER IN connector, or triggering by the
hardkey.
Trigger
Preset
Choices
Location
Remarks
176
PSG-A Series
400.0 Hz
500.0 mHz−100 kHz (minimum increment is 1.0 Hz)
Page 240
This softkey is active only when you have selected the internal source
to operate as Function Generator 1.
PSG-A Series
Free Run
Free Run Trigger Key
Page 240
This softkey is active only when you have selected the internal
source to operate as Function Generator 1.
You can also configure the polarity of the TTL signal output at the
TRIGGER IN connector using the
on this menu. Refer to
Bus
Trigger In Polarity Neg Pos
"Trigger In Polarity Neg Pos" on page
Ext
softkey
222.
Chapter 5