Using Data Storage Functions; Using The Memory Catalog - Agilent Technologies E8241A User Manual

Fundamental Operation

Using Data Storage Functions

Using Data Storage Functions
This section explains how to use the two forms of signal generator data storage: the memory
catalog and the instrument state register.

Using the Memory Catalog

The signal generator's interface for stored files is the memory catalog. From there, you can
view, copy, rename and delete files, either from the signal generator's front panel or via
remote controller. (For information on performing these tasks remotely, see the programming
guide.)
The memory catalog may contain the following file types and their associated data:
bitmap data
BIN
sweep data from the List Mode Values table including frequency, amplitude,
LIST
and dwell time
instrument state data, controlling instrument operating state parameters,
STAT
such as frequency, amplitude, and mode
user flatness calibration correction pair data (user-defined frequency and
UFLT
corresponding amplitude correction values)
Viewing Stored Files
1. Press >
Utility Memory Catalog
The default catalog type is All (all files in the memory catalog are listed in alphabetical
order, regardless of type). When viewing all files, file name listings include their file type,
such as <file name>@STATE or <file name>@LIST.
2. Press .
List
The Catalog of List Files is displayed.
3. Press
Catalog Type
The Catalog of State Files is displayed.
4. Press
Catalog Type
The Catalog of USERFLAT Files is displayed.
44
>
Catalog Type
> .
State
> .
User Flatness
.
Chapter 2