Sweep Repeat Single Cont; Sweep Trigger - Agilent Technologies E8241A User Manual

Sweep Repeat Single Cont

Supported
This softkey toggles the sweep repetition between single sweep and continuous sweep
types. The sweep and point triggers will then trigger the sweep. See
page 191 and "Sweep Trigger" on page
Preset
Choices
Location
Remarks

Sweep Trigger

Supported
Use this softkey to access a menu of choices that enables you to select a triggering mode
for a sweep. You can choose triggering that, once a sweep is armed, occurs immediately,
is supplied by the GPIB, occurs on either the positive or negative edge of a signal
supplied to the TRIGGER IN connector, or is initiated by the
Preset
Choices
Location
Remarks
Chapter 5
All
Cont
Single or Cont
Page 245
None
All
Free Run
Free Run Trigger key
Page 245
You can also configure the polarity of the TTL signal output at the
TRIGGER IN connector using the
on this menu. Refer to
217.
Bus
Trigger In Polarity Neg Pos
"Trigger In Polarity Neg Pos" on page
Key Reference
"Point Trigger" on
hardkey.
Trigger
Ext
softkey
222.
S
217