Φm Sweep Trigger; Φm Tone 1 Rate - Agilent Technologies E8241A User Manual

ΦM Sweep Trigger
Supported
Use this softkey to access a menu of choices that enables you to select the triggering
mode for the swept-sine phase modulation.
Preset
Choices
Location
Remarks
ΦM Tone 1 Rate
Supported
This softkey enables you to set the internal modulation frequency for the phase
modulation tone 1 rate of the dual-sine waveform.
Preset
Range
Location
Remarks
Chapter 5
PSG-A Series
Free Run
Free Run Trigger Key
Page 238
You can also configure the polarity of the TTL signal output at the
TRIGGER IN connector using the
this menu. Refer to "Trigger In Polarity Neg Pos" on page
PSG-A Series
400.0 Hz
0.5 Hz−1.0 MHz (minimum increment is 0.5 Hz)
Page 238
This key is coupled to the
softkey in the ΦM swept-sine menu. Any value set for
ΦM Start Rate
the
ΦM Tone 1 Rate
is reflected in the
Bus
Trigger In Polarity Neg Pos
softkey in the initial ΦM menu and
ΦM Rate
ΦM Rate ΦM Start Rate
and
Key Reference
Symbols
Ext
softkey on
222.
softkeys.
97