Key Reference
S
Set Atten
Supported
This softkey enables you to change the amount of attenuation in 5.0 dB steps. The
output power is the ALC level minus the attenuator setting.
Preset
Range
Location
Remarks
Sine
Supported
This softkey enables you to specify sine as the modulation waveform for the internally
generated, ac-coupled, signal.
Preset
Range
Location
Remarks
Single Sweep
Supported
Use this softkey to arm the sweep. The ARMED annunciator will turn on in the display.
The signal generator will begin the sweep as soon as the sweep trigger is received.
Single Sweep sets the power and the frequency to the first point of the sweep while it is
not initiated or is waiting for the sweep trigger. If you have set the sweep trigger to
, a sweep is initiated as soon as you arm the sweep.
Immediate
Preset
Range
Location
Remarks
212
All with Option 1E1
105.00 dB
0.00 dB−105.00 dB
Page 232
This key is active only when you have toggled the
to On.
PSG-A Series
N/A
N/A
Page
230,
Page
235,
The selected waveform applies only to whichever path configuration
you have currently selected.
All
N/A
N/A
Page 245
This key is disabled when
Page
237,
Page 240
is set to Off.
Sweep
key
Atten Hold Off On
Chapter 5