To Prepare The Function Generator For Use - Agilent Technologies 33120A Service Manual

Chapter
2
Quick Start
To prepare the function generator for use
To prepare the function generator for use
The following steps help you verify that the function generator
is
ready
for use.
1 Check the list of supplied items.
I
Verify that you have received the following items with your function
generator.
If
anything is missing,
contact
yo~xr nearest Hewlett-Parkard
Sales Office.
One power cord.
o
One
User's Guide.
This
Service Guide.
One folded
Quick Reference
card.
Certificate of Calibration.
2 Connect the power cord and turn on the function generator.
If the function generator does not turn on, see Chapter 6 for troubleshooting
information. The front-panel display will light up while the function
generator performs its power-on self-test. The HP-IB bus address is
displayed. Notice that the function generator powers up in the
sine wave
function a t 1
kHz
with an amplitude of 100 mV peak-to-peak (into a 50 Q
termination).
To review the power-on display with all annunciators tuned on, hold
down as you turn on the function generator.
3 Perform a complete self test.
Tho complete self-test performs a more extensive series of tests than
those
performed at power-on. Hold down
as you press the Power switch
t o
turn on the function generator;
hold down the key for more than 5
seconds. The self-test will begin when you release the key.
If the self-test is successful,
"PASS"
is displayed
on
the front panel. If the
self-test is not successful, "FAIL" is displayed and the
ERROR
annunciator
turns on. See
Chapter
6
-
Service
for instructions on returning the
function generator to Hewlett-Packard for service.