Select Seq; Self Test; Set Alc Level - Agilent Technologies E8241A User Manual

Select Seq:

Supported
This softkey enables you to select a sequence for all softkeys which specify a sequence in
this menu. For example, if you want to select sequence 4, press
selected sequence is displayed in the active entry area. Change the number to 4 and
press the
Enter
specify a sequence in this menu.
Preset
Range
Location
Remarks

Self Test

Supported
This softkey accesses an automatic, internal diagnostic test that checks for detectable
hardware failures. If there are hardware failures in the signal generator, refer to the
troubleshooting section of the service guide.
Preset
Range
Location
Remarks

Set ALC Level

Supported
This softkey enables you to change the ALC level. The output power is the ALC level
minus the attenuator setting.
Preset
Range
Location
Remarks
Chapter 5
All
terminator softkey. Sequence 4 is now displayed in all softkeys that
0
0−9
Page 243, Page 244
None
All
N/A
N/A
Page 250
This key is intended for use by service personnel.
All with Option 1E1
−20.00 dBm
−20.00 dBm to 25.00 dBm
Page 232
This key is active only when you have toggled the
to On.
Key Reference
. The currently
Select Seq:
Atten Hold Off On
S
key
211