Am Sweep Trigger; Am Tone 1 Rate; Am Tone 2 Ampl Percent Of Peak - Agilent Technologies E8241A User Manual

AM Sweep Trigger

Supported
Use this softkey to access a menu of choices that enables you to select the triggering
mode for the swept-sine amplitude modulation.
Preset
Choices
Location
Remarks

AM Tone 1 Rate

Supported
This softkey enables you to set the internal modulation frequency for the AM tone 1 of
the dual-sine AM waveform.
Preset
Range
Location
Remarks

AM Tone 2 Ampl Percent Of Peak

Supported
This softkey enables you to adjust the amplitude of the alternate frequency as a
percentage of the total amplitude. For example, if the tone 2 amplitude is set to 30% of
the total amplitude, then the primary frequency is 70% of the total amplitude.
Preset
Range
Location
Remarks
Chapter 5
PSG-A Series
Free Run
Free Run Trigger Key
Page 231
You can also configure the polarity of the TTL signal output at the
TRIGGER OUT connector using the
on this menu. Refer to
PSG-A Series
400.0 Hz
0.5 Hz−1.0 MHz (minimum increment allowed is 0.5 Hz)
Page 231
This softkey is coupled to the
softkey in the AM Dual-Sine menu. Any value set for
AM Start Rate
is reflected in the
AM Tone 1 Rate
PSG-A Series
50.0%
0.1%−99.9%
Page 231
This is applicable for the dual-sine function only.
Bus
Trigger Out Polarity Neg Pos
"Trigger Out Polarity Neg Pos" on page
softkey in the AM menu and the
AM Rate
and
AM Rate
Key Reference
Ext
softkey
222.
softkeys.
AM Start Rate
A
113