Key Reference
A
Amplitude
Supported
This hardkey enables you to change the RF output power. In addition, the key accesses a
menu of choices that enables you to configure the automatic leveling control (ALC),
power search, user flatness, external detector coupling factor, and amplitude options.
The current RF output power level is always shown in the amplitude area of the display
except under the following conditions:
• amplitude reference mode is turned on
• an offset is applied
• a step or list amplitude sweep is in process
The amplitude area of the display is blanked whenever an amplitude sweep is selected.
Preset
Range
Location
Remarks
Atten/ALC Control
Supported
Use this softkey to access a menu of keys that enables you to control the attenuator and
the automatic leveling control (ALC) power level.
Preset
Range
Location
Remarks
118
All
−135.00 dBm (for instruments with Option 1E1)
The output power range depends on your signal generator model. For
more information, refer to the data sheet.
Page 232
None
All with Option 1E1
N/A
N/A
Page 232
None
Chapter 5