Swept-Sine - Agilent Technologies E8241A User Manual

Swept-Sine

Supported
This softkey enables you to specify a swept sinewave as the modulation waveform for the
internally generated, ac-coupled signal, and displays a menu of choices for setting the
parameters. In this menu you can set the start and stop rate and the sweep time. You
can set the signal generator to a single, externally triggered sweep on either a negative
or positive TTL level or you can choose continuous sweep, triggered immediately. In this
menu you can also select either a positive or negative polarity for the TRIGGER OUT
signal.
Preset
Range
Location
Remarks
Chapter 5
PSG-A Series
N/A
N/A
Page 230, Page 235,
Internal 2 is not available for use with the swept-sine function.
Page 237, Page 240
Key Reference
S
219