Point Trigger; Positive; Power Meter - Agilent Technologies E8241A User Manual

Point Trigger

Supported
Use this softkey to access a menu of choices that enables you to select a triggering mode
for point-by-point sweep.
Preset
Choices
Location
Remarks

Positive

Supported
This key enables you to select a positively sloped ramp as the modulation waveform for
the internally generated, ac-coupled signal.
Preset
Range
Location
Remarks

Power Meter

Supported
Use this softkey to access a menu of choices that enables you to select the external power
meter model for use during the user flatness calibration.
Preset
Choices
Location
Remarks
Chapter 5
All
Free Run
Free Run Trigger Key
Page 245
You can also configure the polarity of the TTL signal output at the
TRIGGER IN connector using the
on this menu. Refer to
PSG-A Series
N/A
N/A
Page 230, Page 235,
None
All
N/A
E4418B E4419B
Page 232
The power meter selection is not affected by a preset or by a power
cycle.
The power meter is controlled only through a GPIB cable.
Bus
Trigger In Polarity Neg Pos
"Trigger In Polarity Neg Pos" on page
Page 237, Page 240
E4416A
Key Reference
Ext
softkey
222.
E4417A
P
191