Trigger Out; Trigger In; Source Settled Output - Agilent Technologies E8241A User Manual

Signal Generator Overview
Rear Panel

9. TRIGGER OUT

This BNC connector outputs a TTL signal that is high at the start of a dwell sequence or when
waiting for a point trigger in manual sweep mode. The signal is low when the dwell is over, or
when a point trigger is received. The low-frequency (LF) sweep trigger output can be a high or
low 4 µs pulse.

10. TRIGGER IN

This BNC connector accepts a TTL signal used for point-to-point triggering in manual sweep
mode or a low-frequency (LF) sweep in external sweep mode. Triggering can occur on either
the positive or negative edge of the TTL signal start. The damage level is ≤ −4 V or ≥ +10 V.

11. SOURCE SETTLED OUTPUT

This BNC connector provides an open-collector output indicating when the signal generator
has settled to a new frequency or power level. A high pulse indicates that the source has
settled.
Chapter 1 17