Trigger In Polarity Neg Pos; Trigger Out Polarity Neg Pos - Agilent Technologies E8241A User Manual

Key Reference
T

Trigger In Polarity Neg Pos

Supported
This softkey toggles the polarity of the TTL signal at the TRIGGER IN connector that
triggers an event. When
asserted high (+5.0 V) at the rising edge of the swept-sine modulation sweep and low
(0.0 V) when the sweep is concluded. Setting
the polarity, where the output signal is high at the falling edge (0.0 V) and low at +5.0 V.
Preset
Choices
Location
Remarks

Trigger Out Polarity Neg Pos

Supported
This softkey toggles the polarity of the TTL signal output at the rear panel TRIGGER
OUT connector. When
asserted high (+5.0 V) at the rising edge of the swept-sine modulation sweep and low
(0.0 V) when the sweep is concluded. Setting
the polarity, where the output signal is high at the falling edge (0.0 V) and low at +5.0 V.
Preset
Choices
Location
Remarks
222
All
Trigger In Polarity Neg Pos
Pos
Neg or Pos
Page 231, Page 236,
This key is coupled to the
FM, ΦM, and LF Out, and the Sweep/List menu. When the polarity is
toggled for this key in any one of these menus, it affects all locations of
the key.
All
Trigger Out Polarity Neg Pos
Pos
Neg or Pos
Page 231, Page 236,
This key is coupled to the
FM, ΦM, and LF Out, and the Sweep/List menu. When the polarity is
toggled for this key in any one of these menus, it affects all locations of
the key.
This key is active only when you have selected the internal source to
operate as a function generator.
is set to Pos, the output signal is
Trigger In Polarity Neg Pos
Page 238, Page 241,
Trigger In Polarity Neg Pos
is set to Pos, the output signal is
Trigger Out Polarity Neg Pos
Page 238, Page 240,
Trigger Out Polarity Neg Pos
to Neg reverses
Page 245
key for swept-sine
to Neg reverses
Page 245
key for swept-sine
Chapter 5