Φm Path 1 2; Φm Rate - Agilent Technologies E8241A User Manual

Key Reference
Symbols
ΦM Path 1 2
Supported
This softkey toggles the selection between ΦM Path 1 and ΦM Path 2. ΦM Path 1 and
ΦM Path 2 define two standard phase modulation configurations which can be used
together. Configure the modulation characteristics (such as deviation, source, rate, and
waveform) using the remaining keys in the ΦM menu. Then enable ΦM by setting
ΦM Off On
to On.
ΦM Path 1 and ΦM Path 2 are summed internally for composite modulation. Either path
can be switched to any one of the modulation sources: Internal 1, Internal 2, Ext1, or
Ext2.
Preset
Choices
Location
Remarks
ΦM Rate
Supported
This softkey enables you to change the frequency of the currently selected phase
modulation.
Preset
Range
Location
Remarks
94
PSG-A Series
1
1 or 2
Page 237
ΦM Path 2 must be set to a deviation less than ΦM Path 1.
PSG-A Series
400.0 Hz
0.5 Hz−1.0 MHz (Sine)
0.5 Hz−100 kHz (other waveforms)
Page 237
None
Chapter 5