Dual-Sine; Dwell Type List Step - Agilent Technologies E8241A User Manual

Dual-Sine

Supported
Use this softkey to access a menu of choices that enables you to set the dual-sine
amplitude modulation waveform for the internally generated, ac-coupled signal. You can
set the rates for two separate tones according to modulation type.
• In the AM menu, you can set the depth for Internal 1, and also set a ratio of the tone
2 depth to the tone 1 depth.
• In the FM menu, you can set the deviation for the selected modulation path and also
set a ratio of the tone 2 FM deviation to the tone 1 FM deviation.
• In the ΦΜ menu, you can set the frequencies for two separate tones.
• In addition you can set a ratio of the tone 2 LF amplitude to the tone 1 LF amplitude.
Preset
Range
Location
Remarks

Dwell Type List Step

Supported
This softkey toggles the dwell time for the list sweep points between the values defined
in the list sweep and the value set for step sweep. Choose List to sweep with dwell times
that you have defined in the list sweep. Choose Step and you will sweep each point in the
list with a dwell time set by the
NOTE The dwell time does not begin until the signal generator has settled for the
current frequency and/or amplitude change. When the signal generator
has settled, a trigger signal is transmitted through the rear panel
SOURCE SETTLED OUTPUT connector.
Preset
Choices
Location
Remarks
Chapter 5
PSG-A Series
N/A
N/A
Page 230, Page 235,
None
All
Step Dwell
List
List or Step
Page 246
When you are sweeping using the step sweep dwell time, the list sweep
dwell time values are grayed out to indicate that they are not being
used.
Page 237, Page 240
softkey in the Configure Step Sweep menu.
Key Reference
D
135