Freq Ref Set; Freq Start; Freq Stop - Agilent Technologies E8241A User Manual

Key Reference
F

Freq Ref Set

Supported
Use this softkey to set the current output frequency plus the offset frequency as the
frequency reference value. It also causes the
position, turning on frequency reference mode. All frequency parameters are then set as
relative to the reference value.
Preset
Range
Location
Remarks

Freq Start

Supported
This softkey enables you to set the frequency of the first point in the sweep.
Preset
Range
Location
Remarks

Freq Stop

Supported
This softkey enables you to set the frequency of the last point in the sweep.
Preset
Range
Location
Remarks
154
All
0.00 Hz
100 kHz−highest frequency
Page 239
None
All
Maximum frequency
100 kHz−highest frequency
Page 233, Page 245
None
All
Maximum frequency
100 kHz−highest frequency
Page 233, Page 245
None
softkey to toggle to the On
Freq Ref Off On
Chapter 5