AM Rate
Supported
This softkey enables you to change the frequency for the internally generated
modulation source.
Preset
Range
Location
Remarks
AM Source
Supported
Use this softkey to access a menu of choices that enables you to select either an
internally generated or an externally applied source for amplitude modulation. The
internal modulation is always ac-coupled.
Preset
Choices
Location
Remarks
Chapter 5
PSG-A Series
400.0 Hz
0.5 Hz−100.0 kHz (minimum increment allowed is 0.5 Hz)
0.5 Hz−1.0 MHz if sinewave is selected as the internal waveform
Page 230
The new value of AM rate applies only to the AM configuration you
have currently selected.
PSG-A Series
Internal 1
Internal 1
Internal 2
Page 230
A 1.0 volt peak voltage input is required for calibrated AM depth
settings. The EXT 1 LO/HI and EXT 2 LO/HI display annunciators will
turn on if the peak input voltage differs from 1.0 by more than 3%.
(The LO/HI annunciators only function for ac-coupled external inputs.)
Ext1
Ext2
Key Reference
A
111