Power On Last Preset; Power On/Preset - Agilent Technologies E8241A User Manual

Key Reference
P

Power On Last Preset

Supported
This softkey toggles the power-on state of the signal generator between last and preset.
If you choose Last, each time you cycle power to the signal generator it will turn on in
the same condition as when you turned power off.
If you choose Preset, each time you cycle power to the signal generator it will turn on in
either the factory-defined preset condition or in a user-defined preset condition. You
make the choice between factory- and user-defined preset with the
softkey.
Preset
Choices
Location
Remarks

Power On/Preset

Supported
Use this softkey to access a menu of choices for power on and preset conditions. Refer to
"Power On Last Preset" on page
"Save User Preset" on page
Preset
Choices
Location
192
All
N/A
Last or Preset
Page 247
If last is active, the signal generator must not receive commands for at
least 3 seconds before the power is turned off to guarantee that the
most recent state is saved.
The power-on state is not affected by a preset or by a power cycle.
All
192, "Preset Normal User" on page
207.
N/A
Power On Last Preset
Save User Preset
Page 247
Preset Normal User
Preset Normal User
194, and
Chapter 5