Key Reference
C
Configure List Sweep
Supported
Use this softkey to access a menu of softkeys for defining a list sweep. In this menu you
can insert and delete points in a sweep. Each point can contain frequency, amplitude,
and dwell time information.
NOTE
The dwell time does not begin until the signal generator has settled for the
current frequency and/or amplitude change. When the signal generator
has settled, a trigger signal is transmitted through the rear panel
SOURCE SETTLED OUTPUT connector.
Preset
Range
Location
Remarks
Configure Step Array
Supported
Use this softkey to access a menu of softkeys that enables you to define a user flatness
step sweep. In this menu you can set the start frequency, stop frequency, and the number
of points for the sweep.
Preset
Range
Location
Remarks
124
All
N/A
N/A
Page 245
None
All
N/A
N/A
Page 233
None
Chapter 5