Configuring The Lf Output With An Internal Modulation Source - Agilent Technologies E8241A User Manual

Fundamental Operation
Configuring the LF Output (PSG-A Series Only)

Configuring the LF Output with an Internal Modulation Source

In this example, the internal FM modulation is the LF output source.
Configuring the Internal Modulation as the LF Output Source
1. Press .
Preset
2. Press the
FM/ΦM
3. Press >
FM Dev 75
This sets the FM deviation to 75 kHz.
4. Press >
FM Rate 10
This sets the FM rate to 10 kHz.
5. Press .
FM Off On
The FM annunciator is activated indicating that you have enabled frequency modulation.
Configuring the Low Frequency Output
1. Press the
LF Out
This opens the Low Frequency Output menu. The LF output source is set to internal
modulation 1 by default.
2. Press
LF Out Amplitude Into 50 Ohms
This sets the LF output amplitude to 3 Vp. 3.000 Vp is displayed below the
LF Out Amplitude
3. Press
LF Out Off On
The LF output is a 3 Vp frequency modulated sinewave (the default signal shape), with a
75 kHz FM deviation and 10 kHz rate.
42
hardkey.
> .
kHz
> .
kHz
hardkey.
>
softkey.
.
> .
3 Vp
Chapter 2