Freq & Ampl; Frequency; Function Generator 1 - Agilent Technologies E8241A User Manual

Freq & Ampl
Supported
Use this softkey to set the signal generator to sweep both frequency and amplitude data.
Preset
Range
Location
Remarks

Frequency

Supported
This hardkey enables you to change the RF output frequency. In addition, the key
accesses a menu of softkeys that enables you to configure the reference frequency and
the phase, and specify the oscillator source.
Preset
Range
Location
Remarks

Function Generator 1

Supported
This softkey enables you to select the internal source 1 as a function generator.
Preset
Range
Location
Remarks
Chapter 5
All
N/A
N/A
Page 245
Both the frequency and the amplitude lists must have the same
number of points or one must have only one point. If a list has only one
point, then that point is used for each of the other list's points.
All
20.0 GHz or 40.00 GHz (depends on the signal generator)
The output frequency range allowed depends on your signal generator
model. Refer to the data sheet.
Page 239
None
PSG-A Series
N/A
N/A
Page 240
When you use the internal source in this capacity, any modulation with
the internal source selected is turned off.
Key Reference
F
155