State; Step Dwell - Agilent Technologies E8241A User Manual

Key Reference
S

State

Supported
This softkey enables you to specify that only signal generator instrument state files be
listed in the catalog of files currently displayed.
Preset
Range
Location
Remarks

Step Dwell

Supported
This softkey enables you to set the dwell time for each point of a step sweep. The dwell
time is the amount of time the sweep is guaranteed to pause after setting the frequency
and power for the current sweep/list point.
NOTE The dwell time does not begin until the signal generator has settled for the
current frequency and/or amplitude change. When the signal generator
has settled, a trigger signal is transmitted through the rear panel
SOURCE SETTLED OUTPUT connector.
Preset
Range
Location
Remarks
214
All
N/A
N/A
Page 249
None
All
2.0 msec
1.0 msec−60.0 sec (in 1.0 msec increments)
Page 245
Dwell time is used when the point trigger is set to .
Immediate
Chapter 5