Lf Out Amplitude Into 50 Ohms; Lf Out Freq; Lf Out Off On - Agilent Technologies E8241A User Manual

LF Out Amplitude Into 50 Ohms

Supported
This softkey enables you to scale the output of the signal at the LF OUTPUT connector.
Preset
Range
Location
Remarks

LF Out Freq

Supported
This softkey enables you to set the modulating frequency for the LF output signal when
you have selected the internal source as a function generator.
Preset
Range
Location
Remarks

LF Out Off On

Supported
This softkey toggles the operating state of the output of the selected source at the
LF OUTPUT connector. Refer to the
information on choosing the source.
Preset
Choices
Location
Remarks
Chapter 5
PSG-A Series
0.0 V
0.0−3.5 V
p
Page 240
None
PSG-A Series
400.0 Hz
0.5 Hz−100.0 kHz
0.5 Hz to 1.0 MHz (if sinewave is selected as the internal waveform)
Page 240
This softkey is active only when you have selected the internal source
to operate as a function generator.
PSG-A Series
"LF Out Source"
Off
Off or On
Page 240
Once you have toggled this state on, the signal is immediately
available at the LF OUTPUT connector. The
not apply to this state.The
softkey in this section for more
RF On/Off
softkey does apply to this state.
Mod On/Off
Key Reference
L
hardkey does
173