FM Stop Rate
Supported
This softkey enables you to change the ending frequency of the internally generated
modulation source for swept-sine frequency modulation.
Preset
Range
Location
Remarks
FM Sweep Rate
Supported
This softkey enables you to set the sweep rate for swept-sine frequency modulation.
Preset
Range
Location
Remarks
FM Sweep Trigger
Supported
Use this softkey to access a menu of choices that enables you to select the triggering
mode for the swept-sine frequency modulation.
Preset
Choices
Location
Remarks
Chapter 5
PSG-A Series
400.0 Hz
1.0 Hz−1.0 MHz (minimum increment is 1.0 Hz)
Page 236
This key is coupled to the
menu. Any value set for
softkey.
PSG-A Series
400.0 Hz
0.5 Hz−100.0 kHz
Page 236
N/A
PSG-A Series
Free Run
Free Run
Page 236
You can also configure the polarity of the TTL signal output at
the TRIGGER IN connector using the
softkey on this menu. Refer to
page
222.
softkey in the FM dual-sine
FM Tone 2 Rate
is reflected in the
FM Stop Rate
Trigger Key
Bus
Trigger In Polarity Neg Pos
"Trigger In Polarity Neg Pos" on
Key Reference
FM Tone 2 Rate
Ext
F
149