Trigger; Local Cancel/(Esc); Help; Preset And User Preset - Agilent Technologies X Series User Manual

8. Trigger

When trigger mode is set to Trigger Key, this hardkey initiates an immediate trigger event for a
function such as a list or step sweep.

9. Local Cancel/(Esc)

This hardkey deactivates remote operation and returns the signal generator to front panel control,
cancels an active function entry, and cancels long operations (such an IQ calibration).

10. Help

Use this key to display a description of any hardkey or softkey. See
page 44.

11. Preset and User Preset

These hardkeys set the signal generator to a known state (factory or user–defined). See
the Signal Generator" on page

12. RF Output (N5171B, N5172B, N5181B, N5182B)

Connector Standard:
Option 1EM:
Impedance:
Damage Levels 50 Vdc, 2 W maximum RF power

12. RF Output (N5173B, N5183B)

Connector Option 513/520:
Option 532/540:
Option 1ED
Option 1EM:
Impedance:
Damage Levels 0 Vdc, 0.5 W maximum RF power

13. RF On/Off and LED

This hardkey toggles the operating state of the RF signal present at the RF OUTPUT connector. The
RF On/Off LED lights when RF output is enabled.

14. Mod On/Off and LED

This hardkey enables or disables the modulation of the output carrier signal by an active modulation
format. This hardkey does not set up or activate a format (see
page 59).
The MOD ON/OFF LED lights when modulation of the output is enabled.
Agilent X-Series Signal Generators User's Guide
44.
female Type–N
Rear panel output
50 Ω
male Pecision APC- 3.5
male Precision 2.4 mm
female Type–N
Rear panel output
50 Ω
Signal Generator Overview
"Viewing Key Descriptions" on
"Modulating the Carrier Signal" on
Front Panel Overview
"Presetting
7