Microscan MS-890 User Manual page 199

Calibration
Calibration Embedded Menu Options
START Calibration
Typing A initiates an calibration sequence. Once entered, no other keystrokes will be
accepted with the exception of the ESC key, which terminates the routine.
RECALL Initial Settings
Typing B restores the original settings that were present upon entering the Calibration
Setup Menu. These settings include Motor Speed, Gain, Tracking, and Focus.
SAVE Settings to Database
Typing C saves the current Gain, Tracking, and Focus settings to the Configuration
Database. The database is made up of indexes 1 through 7. Current settings will be saved
to the first open index.
EXIT Calibration Setup Menu
To exit the Calibration Setup menu, press the ESC key. The following prompt will be displayed:
"Do you want to save calibration settings for power on? (Y=yes N=no)."
Typing Y will cause the current settings in the Calibration Setup menu to be saved to
Flash Memory for recall when the scanner is powered up at a later date. These settings
include Motor Speed, Gain, Tracking, Focus, AGC Status, Laser Power, and Raster
Status. Typing N will cause the scanner to be reset without saving the settings to Flash
memory.
Menu Selections
Typing 1 will take you to the Calibration Results menu.
Typing 2 will take you to the Raster/Laser Framing Setup menu.
Typing 3 will take you to the Configuration Database menu.
Typing 4 will take you to the Advanced Setup menu.
9-19
MS-890 Industrial Automation Scanner User Manual