Figure 9: Mpx Power/Standby Button - Tektronix PRISM User Manual

MPX power-on procedure

Figure 9: MPX Power/Standby button

MPX power-off procedure
PRISM Media Analysis Platform User Manual
1. Apply power to the instrument. (See page 16, MPX power cord installation.)
NOTE.
If the MPX monitor was previously powered off by a power interruption
or by removing the power cord from the rear of the instrument, the instrument
will power on when power is reapplied.
2. Press the Power/Standby button on the instrument front panel to turn the
instrument on.
NOTE.
The Power/Standby button illuminates during the power-on sequence and
then turns off during normal instrument operation.
1. Press the Power/Standby button on the instrument front panel to turn the
instrument off.
CAUTION.
To prevent data loss, it is strongly recommended that you first shut
down the instrument using the power button or the Settings > Utilities > Power
submenu before disconnecting the power cord.
2. To completely remove power from the instrument, disconnect the power cord
from the instrument. The power cord has a locking mechanism to keep it
attached to the instrument. Push the button on the cord housing to release the
locking mechanism.
Getting started
17