PRISM Media Analysis Platform User Manual
7. While the upgrade is in process, the message box shown below appears
stating that the firmware installation is in progress.
WARNING.
To prevent upgrade failure, do not remove the USB device or power
off the instrument until the upgrade is complete. The upgrade may take up to
5 minutes.
Figure 53: Upgrade Installation In Process message box
8. When the upgrade is complete, the following message box appears. Perform
one of the following actions:
Touch Reboot Now to reboot the PRISM monitor and complete the
installation of the upgrade.
NOTE.
It is strongly recommended that you select Reboot Now after the
upgrade files are installed. If the instrument does not reboot, remove and then
reapply power to the instrument to cause it to reboot.
Touch Reboot Later to maintain instrument operation with the older
version of firmware. The upgraded firmware will be automatically
installed the next time the instrument is rebooted.
Figure 54: Upgrade Installation Complete message box
9. Remove the USB device from the PRISM monitor.
How to configure the instrument
73
Need help?
Do you have a question about the PRISM and is the answer not in the manual?