Korg Pa4X User Manual page 629

g Feedback
High Damp [%]
h Low Level
High Level
i Wet/Dry
Src
Amt
f: High/Low Split Point
This parameter sets the frequency that splits the high and low range. Only
the high range will be sent to the chorus block.
g: Feedback
Sets the feedback amount of the chorus block. Increasing the feedback will
allow you to use the effect as a flanger.
–100...+100 Sets the feed back amount of the chorus
block
0...100 Sets the high range damping amount of the
chorus block
0...100 Sets the low range output level
0...100 Sets the high range (chorus) output level
Dry, 1:99...99:1, Balance between the wet and dry signal
Wet
Off...Tempo See DMS (Dynamic Modulation Source)
–100...+100 Amount of modulation source
Effect parameters |615