Korg Pa4X User Manual page 733

g MIDI Sync
BPM
Base Note
Times
h Output Level
Src
Amt
i Wet/Dry
Src
Amt
a: Shape
This parameter specifies the sweep curve of the wah. It applies to all control
via auto-wah, modulation source, and LFO, and lets you adjust subtle nu-
ances of the wah effect.
a: Mode
b: Frequency Bottom
b: Frequency Top
c: Resonance Bottom
c: Resonance Top
If Mode=Preset, this simulates a vintage wah pedal. In this case, internally
fixed values are used for Frequency Bottom/Top and Resonance Bottom/
Top, and these settings will be ignored. The settings for Frequency Bottom/
Top and Resonance Bottom/Top are valid if Mode=Custom.
Off, On When this is on, the LFO speed is set by
BPM, Base Note, and Times, instead of
Frequency
MIDI, MIDI syncs to the system tempo; 40–300
40.00... sets the tempo manually for this individ-
300.00 ual effect
Selects the type of notes that specify the
...
LFO speed
x1...x32 Sets the number of notes that specify the
LFO speed
0...100 Sets the output level of the effect sound
Off...Tempo Selects the modulation source that will
control the effect output level
–100...+100 Sets the modulation amount of the effect
output level
Dry, 1:99...99:1, Balance between the wet and dry signal
Wet
Off...Tempo See DMS (Dynamic Modulation Source)
–100...+100 Amount of modulation source
Effect parameters |719