Korg Pa4X User Manual page 405

Choosing and setting the multisamples
▪
Use the High and
or RAM).
▪
Use the numeric field next to the multisample name to choose the multi-
sample inside the selected bank.
Bank
ROM
RAM
The High multisample will be triggered by velocities equal or higher than the
Velocity SW L–>H
switch to a value of 001, and only assign the High multisample.
If you create a new Sound based on RAM samples, the RAM samples must be
loaded from the internal drive or from a device connected to the
ports. In case samples are not loaded, no sound will be heard, even if the
Sound or multisample can be selected and its name appears in the display.
▪
Use the Offset
start to play. With some multisamples this parameter is not available.
Offset
Off
1st...6th
No Attack
AMS
PseudoRandom
▪
Select the Reverse
(reading starts from the end). This can only be activated on some multi-
samples.
▪
Use the Level
Depending on the multisample, high settings of this parameter may cause
the sound to distort when a chord is played. If this occurs, lower the level.
Low pop-up menus to choose the multisample's bank (ROM
Meaning
Factory multisamples, supplied by KORG as standard.
User multisamples, loaded when loading some User Sounds.
value. If you do not want to use velocity switching, set the
parameters to specify the point where the multisample(s) will
Meaning
The sound will start from the beginning of the multisample wave-
form.
The sound will begin from the offset location predetermined for each
sample.
The initial portion of the multisample is ignored.
Activates the Alternate Modulation Source (see below).
(Only works when more than a single Offset point is available in the
multisample). Randomly selects one of the available Offset points.
checkbox to reverse the samples in the multisample
parameters to specify the volume level of each multisample.
Editing the Sounds |391
USB HOST