Korg Pa4X User Manual page 295

3 Use the Value
Value
-127 ... 127
4 Use the Start Tick
of the passage to be transposed.
If a Chord Variation is four measures long, and you want to select it all, the
Start will be positioned at 1.01.000, and the End at 5.01.000.
5 Use the Bottom Note
If you select the same note as the Bottom and Top parameters, you can se-
lect a single percussive instrument in a Drum Kit. Since in a Drum Kit each
instrument is assigned to a different note of the scale, transposing a percus-
sive instrument means assigning the part to a different instrument.
Selective transpose can also be used to avoid transposing RX Noises (trans-
posing only notes under C7).
6 After having set the various parameters, touch Execute.
7 Press the START/STOP
again to stop playback.
Editing Velocity data
You can change the velocity (dynamics) value of notes in the selected track.
When an RX Sound is assigned to the track being edited, the resulting sound
may change, since this kind of Sounds is made of several different layers
triggered by different velocity values.
Also, a fade-out may result in the level 'jumping' up next to the zero, since a
higher-level layer may be selected by low velocity values.
parameter to choose the transpose value.
Meaning
Transpose value (in semitones)
and End Tick
and Top Note
button to check how it works. Press
Editing the Styles and Pads |281
parameters to set the beginning and ending
parameters to set key range to edit.
START/STOP