Korg Pa4X User Manual page 613

g Tap2 Level
Pan
FB Amt
h Tap3 Level
Pan
FB Amt
i Feedback
Src
Amt
j High Damp [%]
Low Damp [%]
k Saturation
l Input Trim
Pre Tone
m Wow Flutter [Hz]
Wow Flutter
depth
n Wet/Dry
Src
Amt
a: Tap1 Dmod Src
b: Tap1 Delay Note
b: Times
c: Tap1 Dmod Note
c: Times
If "Tap1 Dmod Src" is Off or the selected modulation is at 0, the delay time
will be the length specified by "Tap1 Delay Note" and "Times."
If "Tap1 Dmod Src" is other than Off, the delay time will change so that it
will be as specified by "Tap1 Dmod Note" and "Times" when the maximum
modulation is reached.
0...100 Sets the Tap2 output level
L, 1...99, R Sets the stereo image of tap2
–100...+100 Sets the Tap2 feedback amount
0...100 Sets the Tap3 output level
L, 1...99, R Sets the stereo image of tap3
–100...+100 Sets the Tap3 feedback amount
0...100 Sets the amount of feedback for Taps 1, 2, and
3
Off...Tempo Selects the modulation source of feedback
amount
–100...+100 Sets the depth by which feedback amount will
be modulated
0...100 Sets the damping amount in the high range
0...100 Sets the damping amount in the low range
0...100 Sets the distortion amount
0...100 Sets the input gain
0...100 Sets the tone of the input
0.02...1.00 Sets the frequency at which pitch variation will
occur
0...100 Sets the depth of pitch variation
Dry, Balance between the wet and dry signal
1:99...99:1, Wet
Off...Tempo See DMS (Dynamic Modulation Source)
–100...+100 Amount of modulation source
Effect parameters |599