Korg Pa4X User Manual page 705

be controlled by the modulation source specified in the "Wah Sweep Src"
parameter.
d: Pre Low-cut
Cutting the signal in the low range before it is input to the Distortion will cre-
ate a sharp distortion.
d: Drive
e: Output Level
The degree of distortion is determined by the level of input signal and the
setting of "Drive". Raising the "Drive" setting will cause the entire volume
level to increase. Use the "Output Level" parameter to adjust the volume
level. The "Output Level" parameter uses the signal level input to the 3-Band
EQ. If clipping occurs at the 3-Band EQ, adjust the "Output Level" parameter.
OD/HyperGain Wah (Overdrive/Hyper Gain Wah)
This distortion effect has two modes: overdrive and hyper-gain that produc-
es a strong distortion. A higher high-gain setting is required for this effect
relative to a normal-size effect.
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
Left
Pre Low-cut
+
Wah
Right
D
-mod
a Wah
Src
Sw
b Wah Sweep Range
Wah Sweep Src
Mode: Overdrive / Hyper-Gain
Drive
3 Band EQ
Amp Simulation
Driver
Output Level
Direct Mix
Off, On
Off...Tempo
Toggle, Moment
–10...+10
Off...Tempo
Effect parameters |691
FX Amt
FX Amt
Switches Wah on/off
Selects the modulation source
that switches the Wah on and off
Selects the switching
for the modulation source that
switches the Wah on and off
Sets the range of Wah
Selects the modulation source
that controls the Wah
mode