Korg Pa4X User Manual page 573

Hide thumbs Also See for Pa4X:

Mixing the dry (direct) signal and the effects

While in the

between the Wet (effected) and Dry (direct) signal inside the corresponding

FX processor.

With master effects, you can set this value directly from the

Master Effects > FX

We suggest not to change the insert effects' internal mix, unless you are try-

ing to achieve a particular effect. Setting the direct signal of a modulating

effect too low could, for example, cause phasing.

We suggest not to change the master effects' internal mix, unless you are

fine-tuning it, because this is a general setting for the effect. To set the

amount of effect applied to each Sound/channel, use the individual chan-

nels' send level instead.

Choosing a modulation source

You can modulate one of the effect parameters by using MIDI messages gen-

erated by the internal physical controllers or by MIDI data recorded in one of

the Style or Song tracks.

Choose the modulation track

With insert effects, the modulation is always received from the Sound/part/

track they are assigned to. For example, if the insert effect is assigned to the

Upper 1 part, it will be modulated by the Upper 1 part.

With master effects, you must choose a modulating track. Go to the

Effects > FX A/B

M.T. (Modulating Track)

Choose the modulation source

While in the

parameter to choose the physical controller or the type of MIDI

data that will modulate the effect.

Pa4X uses the Dynamic Modulation Source (DMS) system, a highly flexible

and powerful matrix of modulation. See below the list of available sources.

page, use the

page containing the master effect you want to edit, and

parameter to choose the modulating Sound/

page (for both the insert or master effects), use the

parameter to set the balance

The effects |559

Show Quick Links

Troubleshooting