Korg Pa4X User Manual page 940

926| File management
Merging data
When loading all User data, or all data of a specified type, most data loaded
from a storage device are merged with data already existing in memory. For
example, if there is data in all three USER Style banks in memory (USER01,
USER02, USER03), and there is only the USER01 Style bank in the storage
device, the USER01 bank will be overwritten, while USER02 and USER03
banks will be left unchanged.
As a result, there will be a STYLE folder in memory containing the USER01
bank you just loaded, and the old USER02 and USER03 banks.
Loading data based on User Samples
When loading a SET folder containing Sounds based on User Samples, all
existing User Samples in memory are deleted. If there are unsaved User
Samples in memory, save them before loading the folder, by selecting the
PCM option during a
To see if a SET folder contains User Samples, open it and look for a PCM
folder.
If you want to load new User Sample without deleting the ones already con-
tained in memory, load single Sounds instead of a whole SET folder.
Merging User Samples from various sources
When you load a SET folder, all the User Samples in memory are deleted. To
merge samples from several sources, do the following.
1 Load a SET folder containing samples you want to merge with other samples.
2 Load single Sounds from other SET folders.
3 Go to the Sampling mode, and load or import samples from other sources.
4 Save all the content of the memory over the same or a new SET folder.
Save All operation (see later in this chapter).