Korg Pa4X User Manual page 618

604| Effects for the Sounds
e: REC Control Src
g: Manual REC Control
"REC Control Src" selects the modulation source that controls recording.
If this modulation is on, or if "Manual REC Control" is set to On, you can re-
cord the input signal. If a recording has already been carried out, additional
signals will be overdubbed.
The effect is off when a value for the modulation source specified for
the "REC Control Src" parameter is 63 or smaller, and the effect is on when
the value is 64 or higher.
f: RST Control Src
h: Manual RST Control
The "RST Control Src" parameter specifies the modulation source that con-
trols the reset operation.
When you set this modulation source to On, or "Manual RST Control" to RE-
SET, you can erase what you recorded. If the Loop Time parameter has been
set to Auto, the loop time is also reset.
The effect is off when a value for the modulation source specified for
the "RST Control Src" parameter is 63 or smaller, and the effect is on when
the value is 64 or higher.
L/C/R Long Delay
This multitap delay outputs three Tap signals to left, right and center respec-
tively. You can set a maximum of 5,460msec for the delay time.
FX Amt = 100: Mono In - Stereo Out / FX Amt = 0: Stereo In -Stereo Out
Left
Input Level D-mod
+
High Damp Low Damp
Input Level D-mod
Right
a L Delay Time [msec]
Level
L Delay
Level
C Delay
Level
Feedback
R Delay
Level
0...5460 Sets the delay time of TapL
0...50 Sets the output level of TapL
FX Amt
Spread
FX Amt