Korg Pa4X User Manual page 617

b: Loop BPM Sync
c: BPM
d: Loop Base Note
d: Times
If "Loop BPM Sync" is on, the "Times" setting is ignored; the loop time is
determined by "BPM," "Loop Base Note," and "Times." Even in this case, the
delay time cannot exceed 10,800 msec.
"Hold" procedure (when Loop Time = Auto)
1 "Rec Src"JS +Y: #01
"Reset Src"JS –Y: #02
"Manual REC Control"REC Off
"Manual RST Control"RESET
"Loop Time [msec]"Auto
"MIDI/Tempo Sync"Off
It should be noted that all recordings will be deleted while Reset is On.
2 "Manual RST Control"Off
Reset is cancelled and the unit enters Rec ready mode.
3 Push the joystick in the +Y direction (forward) and play a phrase you wish to
hold. When you pull the joystick to its original position, the recording will be
finished and the phrase you just played will be held.
Loop Time is automatically set only for the first recording after resetting.
If the time length exceeds 10,800msec, Loop Time will be automatically
set to 10,800msec. (If you have set "Times" to 1–10,800msec, the specified
loop time will be used regardless of the time taken from pushing the joystick
forward until it is pulled back. However, the recording method remains the
same. The phrase being played while the joystick is pushed forward will be
held.)
4 If you made a mistake during recording, pull the joystick in the –Y direction
(back) to reset. In this way, the recording will be erased. Repeat step 4. again.
5 The recorded phrase will be repeated again and again. You can use this to
create an accompaniment.
6 By pushing the joystick in the +Y direction (forward), you can also overdub
performances over the phrase that is being held.
Effect parameters |603